DS1629
6 of 23
OPERATIONREAL-TIME CLOCK/CALENDAR
DS1629 real-time clock/calendar data is accessed with the 2-wire command protocol C0h. If the R/
bit
in the 2-wire control byte is set to 0, the bus master will set the clock (write to the clock register). The bus
master sets the R/
bit to 1 to read the current time (read from the clock register). See the 2-Wire Serial
Bus section for details on this protocol.
The format of the clock register is shown below in Figure 2. Data format for the clock register is binary-
coded decimal (BCD). Most of the clock register is self-explanatory, but a few of the bits require
elaboration.
CH = Clock halt bit. This bit is set to 0 to enable the oscillator and set to 1 to disable it. If the bit is
changed during a write to the clock register, the oscillator will not be started (or stopped) until the bus
master issues a STOP pulse. The DS1629 power-up default has the oscillator enabled (CH = 0) so that
OSC can be used for clocking a microcontroller at power-up.
12/24 = Clock mode bit. This bit is set high when the clock is in the 12-hour mode and set to 0 in the 24-
hour mode. Bit 5 of byte 02h of the clock register contains the MSb of the hours (1 for hours 20-23) if the
clock is in the 24-hour mode. If the clock mode is set to the 12-hour mode, this is the AM/PM bit. In the
12-hour mode, a 0 in this location denotes AM and a 1 denotes PM. When setting the clock, this bit must
be written to according to the clock mode used.
Bits in the clock register filled with 0 are a dont care on a write, but will always read out as 0.
DS1629 CLOCK REGISTER FORMAT Figure 2
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
DS1631S+T&R
IC THERMOMETER DIG HI-PREC 8SOIC
DS1721U+T&R
IC THERMOMETER/STAT DIG HP 8USOP
DS1722S
IC THERMOMETER DIG 3-WIRE 8-SOIC
DS1775R7+T&R
IC THERMOM/STAT DIG 111 SOT-23-5
DS1821C+
IC THERMOMETER/STAT PROG 3-TO92
DS1825U+T&R
IC THERMOMETER DIGITAL 8-USOP
DS1842N+T&R
IC CURRENT MONITOR 14TDFN
DS18B20+PAR
IC THERM MICROLAN PROG-RES TO-92
相关代理商/技术参数
DS1629S-C03+
功能描述:板上安装温度传感器 RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
DS1629S-C03+T&R
功能描述:板上安装温度传感器 RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
DS1629S-C05+
功能描述:板上安装温度传感器 Digital Thermometer & RTC/Calendar
RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
DS1629S-C05+T&R
制造商:Maxim Integrated Products 功能描述:DS1629S REV A5 TR - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC THERM/RTC/CALENDAR DGTL 8SOIC 制造商:Maxim Integrated Products 功能描述:Board Mount Temperature Sensors Digital Thermometer & RTC/Calendar
DS1629S-C05+T&R
功能描述:板上安装温度传感器 Digital Thermometer & RTC/Calendar RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
DS1630AB-100-IND
制造商:未知厂家 制造商全称:未知厂家 功能描述:NVRAM (Battery Based)
DS1630AB-120-IND
制造商:未知厂家 制造商全称:未知厂家 功能描述:NVRAM (Battery Based)
DS1630AB-70-IND
制造商:未知厂家 制造商全称:未知厂家 功能描述:NVRAM (Battery Based)